In the process of wallpaper paving, many people think that weighed against parquet wallpaper, plain wallpaper is simpler and far more convenient to use without mosaic. As it happens that plain wallpapers are basic and easy to lay out because they haven’t any patterns, however the relative stitching requirements are more stringent. Plain colors, especially darker plain shades, are relatively more prone to seam problems. If the simple wallpaper has a seam phenomenon, what’s the explanation for judging the seam? After that take the right approach.
1. There is a gap
If the seam is seen at 1.5m on leading side, there is absolutely no color difference in the wallpaper. Is it serious to cope with the seams during building? Most of the factors behind the seams are due to construction problems.
Approach
1. If the wallpaper is a rubberized wallpaper, you can wet the seam with a wet towel, open up the wallpaper glue, softly pry open up the wallpaper, and then use the wallpaper softener to soften the wallpaper to extend the wallpaper and fix the seams.
2. If it is a 100 % pure paper wallpaper or a nonwoven wallpaper, there is almost no stretchability, so it can’t be repaired by the above method. The base could be shaded with a paint-coated seam that’s similar in color to the wallpaper.
2.Yin and Yang
If there is obviously no overall feeling between your wallpaper strips at 1.5m on the front aspect, the seams of the wallpapers are handled well in close distances, and there is no apparent seam phenomenon. It appears that the wallpaper appears like a color difference, and the color difference at the seam is normally in accordance with the obvious law of deep-shallow-deep-light or shallow-deep-shallow-deep, which may be caused by the yin and yang.
Find the label of the wallpaper and see when there is an alternate label on the top and bottom of the label – ↑↓.
Approach
1. If there is, it needs to become alternately pasted based on the logo design, ie: shallow-shallow-deep-deep relative to avoid the phenomenon of yin and yang.
2. If there is no logo, it really is caused by the product quality problem of the wallpaper. There is no solution and it is necessary to respond to the wallpaper sales office.
3 white side
If underneath paper is Mica Wall paper available to be slightly longer when the dark wallpaper is constructed, there will be a white edge at the seam following the construction. The gap is normally clearly visible at a distance of 1 1.5 m from the front of the wall.
Approach
1. Because the wallpaper isn’t constructed with simple wallpaper, the seam could be treated by the technique of edging.
2. If the wallpaper has been constructed, it can be used in the same color as the wallpaper. (That is a versatile method)
4 overflow glue
The plain wallpaper is not easy to erase after filled with glue, and there are residual rubber marks after rubbing.
Precautions
1. When constructing, make sure to check whether there is an “along alternate” construction tag on the wallpaper label. If there is this logo design, the wallpaper ought to be positively and negatively posted. When there is still a positive and negative surface area phenomenon, you can try normal stickers again.
2, plain color non-woven wallpaper construction should try to avoid spilling glue, avoid wiping, after the wiping strength is usually large, it may leave traces. In case you are unfortunate plenty of to spill the glue, you should clean the spilled glue in the tiniest range, and the softer color of the basic wallpaper ought to be gentle.
3, rubber surface plain wallpaper, the first wallpaper paste for around 30 minutes must focus on check if the seams of the wallpaper have offset printing. When there is offset printing, it means that the rubberized wallpaper can’t overflow, and the glue will keep traces.